Help Center · 🛠 Troubleshooting
Fixing microphone and audio problems
Beginner · 2 min read
What to do when your mic is blocked, a sketch is silent, or your recorded takes sound late.
Most audio problems in TRAX come down to three things: microphone permission, the first tap on a phone, and latency. Here's how to fix each one.
The microphone is blocked
If TRAX can't hear you, your browser may be blocking the microphone.
- Open your browser's site settings for TRAX.
- Allow microphone access.
- Go back to TRAX and try recording again.
If you tapped "Block" by accident when your browser first asked, this is how to undo it.
No sound on a phone
Phones need a tap before audio plays, and iPhone is especially strict about it. In the Mobile Creation Studio, tap Tap to start the studio first. If a page is still silent, tap once and press play again.
Also check the basics: the volume is up, the phone isn't muted, and your headphones are connected.
Takes sound late
If what you record lands behind the beat, adjust the take offset.
- In a sketch, open ⚙ settings.
- Adjust the take offset, which corrects for latency.
- Record a short test and listen back.
- Repeat until your takes sit on the beat.
As a starting point, Chrome on Android is usually 20–50 ms, and iPhone Safari is usually 200–400 ms.
Echo or feedback
Wear headphones when you record. Without them, the loop plays through your speaker and back into your mic.
Notes are out of time or out of key
- Set Auto-quantize on the track, or use Quantize now.
- Use Fix out-of-key notes to snap notes to the sketch's key.
Voice effects sound wrong
Effects are non-destructive, and your raw take is always kept. Switch to another preset, or remove the effect, and your original recording is still there.
💡 Record with headphones every time. It prevents echo and keeps your takes clean.
Still stuck?
Search the Help Center, read the FAQ, or contact support. New to TRAX? Start free. A member? Log in to come back here with the full Help Center.
