Help Center 路 馃帣 Creating & Capturing

Autotune Lite and Hum-to-MIDI

Beginner 路 3 min read

Pull a voice take into your sketch's key with Transparent or Hard correction, and hum a melody to turn it into notes on a melody track.

Both tools live in the Mobile Creation Studio and run on your device. Your audio isn't sent anywhere to do it, and your original take is never changed.

Autotune Lite

Select a voice or imported track that has a take, then switch on Autotune Lite under the track's editor.

  • Transparent moves only the notes that are off, by as much as the Strength slider allows. Notes already within a few cents stay as you sang them, so it sounds like a gentle touch-up.
  • Hard snaps every note fully and quickly to the nearest note in the key. That's the stepped, robotic sound.
  • Key follows your sketch's key. Pick another key, or Nearest note (no key) to pull to any semitone.

TRAX shows how much of the take it moved and by how much, with a line that goes up where it sharpened and down where it flattened. Tick Hear the original to compare, and untick it to hear the tuned take again. Only the part of the take that plays (between the trim points) is tuned, so long imports stay quick.

What you hear in the studio is what goes in your bounce and stems.

Save it for Quick Capture

Save as an FX preset keeps your setting as a custom preset you can pick in Quick Capture's voice effects. A quick capture has no key, so there it pulls to the nearest note. Hard saves as Hard; Transparent saves up to 85% (from 90% the effect plays as Hard).

Good to know

  • It works on one voice at a time. Chords, harmonies and full mixes won't tune cleanly.
  • Very breathy, whispered or noisy takes give it less to work with.
  • In Quick Capture, monitoring while you record plays a preview flavor of the effect. The real correction happens when the recording plays back.

Hum-to-MIDI

Select a melody track and press 馃幎 Hum a melody.

  1. You get one bar of clicks to count you in, then the clicks carry on for the length of your loop.
  2. Hum, sing "doo" or whistle one note at a time. A line shows the pitch TRAX is hearing.
  3. When the loop ends (or you press Stop), TRAX finds the notes and shows them on a small piano roll.

Before you drop them in, you can:

  • Snap to the key so every note lands in your sketch's key
  • Move it an octave up or down
  • Replace the notes already on the track, or add to them
  • Keep the hum as a muted voice track, so you can hear what you hummed later (this one is uploaded with your sketch, like any take)

Press Use these notes and they're ordinary notes. Change the instrument, quantize them, fix out-of-key notes or play over them, just like notes you played on the keys.

Tips for a clean result

  • Hum close to the mic in a quiet room and wear headphones so the clicks don't get picked up.
  • Leave a small gap between notes. Very short blips (under about a tenth of a second) are skipped.
  • If nothing comes through, TRAX tells you. Try a little louder, one note at a time.

Plans

Autotune Lite and Hum-to-MIDI are part of the Mobile Creation Studio on every plan.

Still stuck?

Search the Help Center, read the FAQ, or contact support. New to TRAX? Start free. A member? Log in to come back here with the full Help Center.

Autotune Lite and Hum-to-MIDI 路 Help 路 TRAX